3Com MSR 50 manual Display ipv6 interface tunnel, Syntax display ipv6 interface tunnel number, 883

883

Table 189 Description on fields of the display interface tunnel command

Field	Description
aggregation ID	Link aggregation group ID referenced by a tunnel. If
	the device supports link aggregation groups, the link
	aggregation group ID configured in tunnel interface
	view is displayed. If device does not support,
	“aggregation ID not set” is displayed.
Tunnel source	Source address of a tunnel.
destination	Destination address of a tunnel.
Tunnel keepalive disable	Disables the keepalive function of the GRE so as not to
	detect the tunnel interface state.
Tunnel protocol/transport	Tunnel protocol and transport protocol.
GRE key disabled	No key is configured for the GRE tunnel interface.
Checksumming of GRE packets	Disables the GRE packet checksum function.
disabled
Last 300 seconds input	Number of bytes and packets input per second in the
	last five minutes.
Last 300 seconds output	Number of bytes and packets output per second in the
	last five minutes.
packets input	Total number of input packets.
input error	Number of error packets among all input packets.
packets output	Total number of output packets.
output error	Number of error packets in all output packets

display ipv6 interface tunnel

Syntax display ipv6 interface tunnel number

View Any view

Parameter number: Tunnel interface number.

Description Use the display ipv6 interface tunnel command to display related IPv6 information of a specified tunnel interface, including link state, IPv6 protocol state, and IPv6 address.

Example # Display information of the interface tunnel 0.

<Sysname> display ipv6 interface tunnel 0 Tunnel0 current state :UP

Line protocol current state :UP

IPv6 is enabled, link-local address is FE80::101:101

Global unicast address(es):

2002:101:101::1, subnet is 2002::/16 Joined group address(es):

FF02::1:FF01:101

FF02::1:FF00:1

FF02::2

FF02::1

MTU is 1500 bytes