3Com MSR 50, MSR 30 Resetkey, Rta bind, Related command display rta, Undo resetkey, Undo rta bind

913

Parameters terminal-number: Terminal number, ranging 1 to 255.

Description Use the reset rta statistics command to clear the statistics of a terminal.

Related command: display rta.

Example # Clear all the statistics about terminal 1.

<Sysname> reset rta statistics 1

resetkey

Syntax resetkey ascii-code&<1-3>

undo resetkey

View Terminal template view

Parameters ascii-code&<1-3>: ASCII value of a hotkey, ranging 1 to 255. “&<1-3>” means that you can provide up to three ASCII values.

Description Use the resetkey command to set the terminal reset hotkey.

Use the undo resetkey command to cancel the configured terminal reset hotkey.

By default, no terminal reset hotkey is configured.

After you press the terminal reset hotkey when a terminal fault occurs, the router tears down and then reestablishes the TCP connection with the FEP.

Note that the ASCII value of the redrawing hotkey configured must be different from that of any other hotkey configured on the device. Otherwise, hotkey conflicts will occur. For example, the hotkey value cannot be set to 17 or 19 because these two values are used for the hotkeys of flow control. Using the hotkey may not get a response rapidly when the terminal displays too much data.

Example # Configure the terminal reset hotkey as <Ctrl+A> by setting its ASCII value to 1.

<Sysname> system-view

[Sysname] rta template abc

[Sysname-rta-template-abc] resetkey 1

rta bind

Syntax rta bind { mac-address interface interface-type interface-number string string }

undo rta bind

View System view