3Com MSR 50, MSR 30 manual Related commands peer timer BGP/BGP-VPN instance view, 1013

1013

Use the undo timer command to restore the default.

By default, BGP keepalive and holdtime intervals are 60s and 180s.

Note that:

■Timer configured using the peer timer command is preferred to the timer configured using this command.

■The holdtime interval must be at least three times the keepalive interval.

■The configured timer applies to all the BGP peers, while it becomes valid only after the corresponding BGP connections are reset.

Related commands: peer timer (BGP/BGP-VPN instance view).

Examples # Configure keepalive interval and holdtime interval as 60s and 180s.

<Sysname> system-view [Sysname] bgp 100

[Sysname-bgp] timer keepalive 60 hold 180

#In BGP-VPN instance view, configure keepalive interval and holdtime interval as 60s and 180s (the VPN has been created).

<Sysname> system-view [Sysname] bgp 100

[Sysname-bgp] ipv4-family vpn-instance vpn1 [Sysname-bgp-vpn1] timer keepalive 60 hold 180