3Com MSR 50, MSR 30 manual Primary authentication Hwtacacs scheme view, 1981

1981

■If you configure the command for more than one time, the last configuration takes effect.

■You can remove an accounting server only when no active TCP connection for sending accounting packets is using it.

Example # Configure the primary accounting server.

<Sysname> system-view

[Sysname] hwtacacs scheme test1

[Sysname-hwtacacs-test1] primary accounting 10.163.155.12 49

primary authentication (HWTACACS scheme view)

Syntax primary authentication ip-address[ port-number]

undo primary authentication

View HWTACACS scheme view

Parameter ip-address: IP address of the server, a valid unicast address in dotted decimal notation. The default is 0.0.0.0.

port-number: Port number of the server. It ranges from 1 to 65535 and defaults to 49.

Description Use the primary authentication command to specify the primary HWTACACS authentication server.

Use the undo primary authentication command to remove the configuration.

Note that:

■The IP addresses of the primary and secondary authentication servers cannot be the same. Otherwise, the configuration fails.

■The HWTACACS service port configured on the device and that of the HWTACACS server must be consistent.

■If you configure the command for more than one time, the last configuration takes effect.

■You can remove an authentication server only when no active TCP connection for sending authentication packets is using it.

Related command: display hwtacacs.

Example # Set the primary authentication server.

<Sysname> system-view

[Sysname] hwtacacs scheme hwt1

[Sysname-hwtacacs-hwt1] primary authentication 10.163.155.13 49