3Com MSR 30, MSR 50 manual Qos wfq, Undo qos wfq, Display interface, display qos wfq interface

1824 CHAPTER 114: WFQ CONFIGURATION COMMANDS

qos wfq

Syntax	qos wfq [ precedence dscp ] [ queue-length max-queue-length[ queue-number
	total-queue-number ] ]
	undo qos wfq
View	Interface view
Parameters	precedence: Weight type of IP precedence.
	dscp: Weight type of DSCP ( DiffServ code point).
	max-queue-length: Maximum queue length, or maximum number of packets in
	each queue. It ranges from 1 to 1024 and defaults to 64. Packets out of the range
	will be discarded.
	total-queue-number: Sum of queues. When IP precedence applies, available
	numbers are 16, 32, 64, 128, 256, 512, 1024, 2048 and 4096. When dscp
	applies, available numbers are 64, 128, 256, 512, 1024, 2048 and 4096. The
	default is 256.
Description	Use the qos wfq command to apply WFQ to the interface or modify WFQ
	parameters on the interface.
	Use the undo qos wfq command to restore the default congestion management
	mechanism FIFO.
	Except for interfaces encapsulated with X.25, all physical interfaces can use WFQ.
	When WFQ is not used on interface, use the qos wfq command to enable the
	interface to use WFQ policy and specify WFQ parameters. When WFQ is used on
	interface, use the qos wfq command to modify WFQ parameters.
	The weight type is precedence by default if no weight type is configured,
Related commands:	display interface, display qos wfq interface.
Examples	# Apply WFQ at the Ethernet 1/0 interface, set the queue length to 100 and set
	the total queue number to 512.
	<Sysname> system-view
	[Sysname] interface Ethernet1/0
	[Sysname-Ethernet1/0] qos wfq queue-length 100 queue-number 512