2642 CHAPTER 174: DIAL PLAN CONFIGURATION COMMANDS

<Sysname> system-view [Sysname] voice-setup [Sysname-voice] dial-program [Sysname-voice-dial] entity 10 pots [Sysname-voice-dial-entity10] select-stop

send-number

Syntax send-number { digit-numberall truncate }

undo send-number

View POTS entity view

Parameter digit-number: Number of digits (that are extracted from the end of a number) to be sent, in the range of 0 to 31. It is not greater than the total number of digits of the called number.

all: Sends all digits of a called number.

truncate: Sends a truncated called number.

Description Use the send-numbercommand to configure the number sending mode.

Use the undo send-numbercommand to restore the default number sending mode.

By default, the truncate mode is used.

Note that:

This command applies to only POTS voice entities. This command is used to control how to send called numbers to PSTN. You can specify to send some digits (defined by the digit-number argument from right to left) or all digits of called numbers. You can also specify to send truncated called numbers, namely, the ending digits of called numbers that match the dot.

Here the dot represents the virtually matched digits. For details, refer to “dot-match” on page 2628 and “match-template” on page 2599.

Related command: dot-matchand match-templateon page 2599.

Example # Configure voice entity 10 to send the last six digits of a called number.

<Sysname> system-view [Sysname] voice-setup [Sysname-voice] dial-program [Sysname-voice-dial] entity 10 pots

[Sysname-voice-dial-entity10] send-number 6

Page 2642
Image 2642
3Com MSR 30, MSR 50 manual Send-number, Related command dot-matchand match-templateon