3Com MSR 30, MSR 50 manual Reset stp interface interface-list, Display stp

606CHAPTER 38: MSTP CONFIGURATION COMMANDS

Parameters	name: Name of the MST regions, a string of 1 to 32 characters.
Description	Use the region-namecommand to configure the MST region name of your
	device.
	Use the undo region-namecommand to restore the MST region name to the
	default setting.
	By default, the MST region name of a device is its MAC address.
	The MST region name, the VLAN-to-instance mapping table and the MSTP revision
	level of a device jointly determine the MST region the device belongs to.
Related commands:	instance, revision-level,check region-configuration,vlan-mapping
	modulo, and active region-configuration.
Examples	# Set the MST region name of the device to “hello”.
	<Sysname> system-view
	[Sysname] stp region-configuration
	[Sysname-mst-region] region-name hello

reset stp

Syntax	reset stp [ interface interface-list]
View	User view
Parameters	interface interface-list: Clears the spanning tree statistics information on one or
	multiple ports. You can provide up to 10 port lists, by each of which you can
	specify an individual port in the form of interface-typeinterface-number, or a port
	range in the form of interface-type start-interface-number to interface-type
	end-interface-number, where the end port number must be greater than the start
	port number.
Description	Use the reset stp command to clear the MSTP statistics information.
	The MSTP statistics information includes the numbers of TCN BPDUs,
	configuration BPDUs, RST BPDUs and MST BPDUs sent/received through the
	specified port(s) (STP BPDUs and TCN BPDUs are counted only for the CIST).
	This command clears the spanning tree-related statistics information on the
	specified port(s) if you specify the interface-listargument; otherwise, this
	command clears the spanning tree-related statistics on all ports.
Related commands:	display stp.
Examples	# Clear the spanning tree-related statistics information on ports Ethernet 1/1
	through Ethernet 1/3.

<Sysname> reset stp interface Ethernet 1/1 to Ethernet 1/3