3Com MSR 50 179, Vofr Configuration Commands, Address, Undo address vofr-dynamic vofr-static

179

address

VOFR CONFIGURATION COMMANDS

Syntax	address { vofr-dynamic serial interface-numberdlci-numbervofr-static serial
	interface-number dlci-number cid-number }
	undo address { vofr-dynamic vofr-static }
View	VoFR entity view
Parameter	vofr-dynamic: Specifies a VoFR entity to adopt the dynamic call mode.
	vofr-static: Specifies a VoFR entity to adopt the FRF.11 trunk mode.
	serial interface-number: Specifies the destination interface of a VoFR entity.
	dlci-number: Destination virtual circuit number of a VoFR entity, in the range of 16
	to 1007.
	cid-number: Destination FRF.11 sub-channel number of a VoFR entity, in the range
	of 4 to 255.
Description	Use the address command to configure a channel to the peer voice gateway.
	Use the undo address command to remove the configuration.
	By default, no channel to the peer voice gateway is configured.
	Note that:
	■ The FRF.11 sub-channel number to be configured must be available. That is, the
	FRF.11 sub-channel is not occupied.
	■ A voice channel will be established for the VoFR entity immediately you execute
	the address vofr-staticcommand. The voice channel will be removed after
	you execute the undo form of the command or delete the VoFR entity.
Related command:	call-mode,vofr, trunk-id, and display fr vofr-info.
Example	# Specify DLCI 100 to adopt the dynamic call mode.
	<Sysname> system-view
	[Sysname] voice-setup
	[Sysname-voice] dial-program