553

bridge routing-enable

Syntax bridge routing-enable
undo bridge routing-enable
View System view
Parameters None
Description Use the bridge routing-enable command to enable bridge routing.
Use the undo bridge routing-enable command to disable bridge routing.
By default, bridge routing is disabled.
Routing of a particular protocol can be implemented only if bridge routing is
enabled.
Example # Enable bridge routing.
<Sysname> system-view
[Sysname] bridge routing-enable

bridge-set

Syntax bridge-set bridge-set
undo bridge-set bridge-set
View Interface view
Parameters bridge-set: Bridge set number, an integer in the range of 1 to 255.
Description Use the bridge-set command to add the current interface into a bridge set.
Use the undo bridge-set command to remove the current interface from a
bridge set.
By default, a bridge set does not contain any interface.
Example # Add Ethernet1/0 into bridge set 1.
<Sysname> system-view
[Sysname] interface ethernet1/0
[Sysname-Ethernet1/0] bridge-set 1
Promiscuous operation mode was set automatically.
n■As shown above, after being added into bridge set 1, Ethernet1/0
automatically works in the promiscuous operation mode. When working in the