3Com MSR 50, MSR 30 Undo x25 pvc pvc-number1, Related command display x25 vc, x25 switching, 471

471

undo x25 pvc pvc-number1

View Interface view

Parameter pvc-number1: Number of PVC on the local interface, in the range 1 to 4095. ip-address: IP address of the peer on the XOT connection.

interface interface-typeinterface-number: Specifies an interface by its type and number.

pvc pvc-number2: Specifies a PVC on the peer interface. The pvc-number2argument is in the range 1 to 4095.

xot-option: XOT channel parameter option. For specific configuration, see Table 72.

Table 72 XOT channel parameter option

Option	Description
timer seconds	Keepalive timer delay of XOT connection. The timer sends the
	keepalive packet upon timeout to detect the connection
	availability. Its value ranges from 1 to 3600.
retry times	Number of maximum retries for sending keepalives. If the number
	exceeds times, the XOT connection will be disconnected. Its value
	ranges from 3 to 3600.
source interface-type	Type and number of the interface that initiates the XOT
interface-number	connection.

packet-sizeinput-packetoutput-packet: Specifies the maximum input and output packet lengths in bytes, in the range 16 to 4,096. The sizes must be an integer power of 2.

window-sizeinput-window-size output-window-size: Specifies the input and output window sizes of the VC. If the modulo of the PVC’s interface is 8, the values are in the range 1 to 7; if the modulo is 128, the values are in the range 1 to 127.

Description Use the x25 xot pvc command to add a PVC route of XOT.

Use the undo x25 pvc command to delete the specified PVC route of XOT.

By default, no PVC route of XOT is configured.

XOT (X.25 Over TCP) is a protocol to load X.25 packet over TCP. Configuring the XOT switching PVC can connects the local X.25 network to the remote one over the IP network. You can also configure the keepalive attribute to support link detection.

Related command: display x25 vc, x25 switching.

Example # Configure an XOT PVC route to forward packets from PVC1 to the device at 10.1.1.2, which then forwards the packets out PVC2 on Serial 2/0.