3Com MSR 30, MSR 50 manual Ipx route max-reserve-path, Ipx sap disable

2544 CHAPTER 172: IPX CONFIGURATION COMMANDS

Description Use the ipx route load-balance-pathcommand to specify the maximum number of equivalent routes to the same destination.

Use the undo ipx route load-balance-pathcommand to restore the default.

The default is 1.

This number is the maximum active equivalent route number of the system. If a newly configured number is smaller than the previous, the system will change the excessive active routes to inactive routes.

Example # Specify the maximum equivalent route number to the same destination address as 30.

<Sysname> system-view

[Sysname] ipx route load-balance-path 30

ipx route max-reserve-path

Syntax ipx route max-reserve-path paths

undo ipx route max-reserve-path

View System view

Parameter paths: Maximum number of routes to the same destination, including both static and dynamic routes, in the range 1 to 255.

Description Use the ipx route max-reserve-pathcommand to specify the maximum number of routes to the same destination.

Use the undo ipx route max-reserve-pathcommand to restore the default.

By default, the value is 4.

When the route number to the same destination address exceeds the maximum value configured, the newly found dynamic routes will not be added into the routing table, but discarded directly. If the newly configured value is less than the original one, the excessive routes in the current routing table will not be deleted until they get aged out or are deleted manually.

Example # Specify the maximum number of routes to the same destination to 200.

<Sysname> system-view

[Sysname] ipx route max-reserve-path 200

ipx sap disable

Syntax ipx sap disable

undo ipx sap disable