Paradyne 3800 manual of DTE Dialer Configuration Options, V.25b NewLineChr CR+LF Nxt CR+LF CR LF

Configure Branch

Table 9-2

(5 of 5)

DTE Dialer Configuration Options

V.25b NewLineChr: CR+LF

Nxt CR+LF CR LF

V.25bis New Line Character. Sets the modem for the command line terminator used by the DTE in V.25bis Async mode. The modem responds to the DTE using the same line terminator.

NOTE: This configuration option only appears if DTE Dialer is configured for V25bis Async.

The factory default is CR+LF.

AT command is S-register S64 = n, where n is 0 for carriage return and line feed, 1 for carriage return, or 2 for line feed.

DTR Cont Repeat: Disable

End Disable Enable

DTR Cont Repeat. Determines whether automatic redialing stops after the directory locations defined by DTR Auto Redial (S37) have all been tried unsuccessfully once. If DTR Cont Repeat is enabled, automatic redialing starts again with directory location 1. The default is Disable.

A redial attempt is made in response to a bad phone number, a busy signal, no answer, or no quiet answer. However, a lockout from redialing occurs if ten successive failing call attempts are made to the same number.

DTR Cont Repeat is accessible only if the DTE Dialer Type is DTR=Dirs.

Disable – Automatic redialing will not be repeated.

Enable – Automatic will be repeated if necessary.

AT command is S-register S38 = n, where n is 0 for Disable and 1 for Enable.

3810-A2-GB30-30 September 1998 9-19