Paradyne manual 5 of 3800 Series S-Registers, Description, Front Panel Branch, Auto Make Busy

AT Command Set and S-Registers

S-Register

Table 14-2

(5 of 12)

3800 Series S-Registers

Description Front Panel Branch

S39	Receive Buffer Disconnect Delay				Configure\Edit\
	Determines the maximum amount of time the modem can continue to				V42/MNP/Buffer
	send data in its Receive Buffer to the DTE after the modem is
	commanded by the DTE to disconnect, or after the modem detects a line
	disconnect.
	Register has the following values:
	S39	= 0	Disable (Immediate disconnect)
	S39	= 1	1 second
	S39	= 2	2 seconds
	S		S	S
	S		S	S
	S39	= 255	255 seconds
	Factory setting is Disable (0).
S40	Auto Make Busy				Configure\Edit\Line Dialer
	Register determines if the modem goes off-hook under certain
	conditions. This register should only be enabled when the modem is
	located behind a user’s Private Branch Exchange (PBX). This register is
	only valid for Model 3811 modems.

Register has the following values:

	0	= Disable
	1	= Enable
	Factory setting is Disable.
S41	Dial-Line Rate		Configure\Edit\Dial Line
	Register determines the modem’s data rate and modulation scheme for
	operation on dial lines.
	Register has the following values:

1= 4400 (V.32bis)

2= 12,000 (V.32bis)

3= 9600 (V.32bis/V.32)

4= 7200 (V.32bis)

5= 4800 (V.32bis/V.32)

6= 2400 (V.22bis)

7= 1200 (V.22)

8= 1200 (212A)

10= 0–300 (V21)

11= 0–300 (103J)

20= 19,200 (V.32terbo)

21= 16,800 (V.32terbo)

Factory setting is 19,200 (V.32terbo).

S43	V.32bis Train		Configure\Edit\Dial Line
	Register controls the modem’s train time for V.32bis/V.32 mode.
	Register has the following values:
	0	= Long
	1	= Short
	Factory setting is Long.

3810-A2-GB30-30 September 1998 14-19