Paradyne 4 of 3800 Series S-Registers, Description, Front Panel Branch, Rate Auto Originate

COMSPHERE 3800 Series Modems

S-Register

Table 14-2

(4 of 12)

3800 Series S-Registers

Description Front Panel Branch

S36

Rate Auto Originate

Initiates a dial backup call, using the phone number in directory

location 1, when the leased-line rate of the modem falls back to or below a certain speed.

Register has the following values:

S36 = 0 Disable

S36 = 1 On fallback to 4800

S36 = 2 On fallback to 7200

S36 = 3 On fallback to 9600

S36 = 4 On fallback to 12,000

S36 = 5 On fallback to 14,400

S36 = 6 On fallback to 16,800

NOTE: Rate Auto-Originate is valid only when V.32bis Autorate is enabled (S76 = 0).

Configure\Edit\Leased Line

S37	Auto Redial (DTR)			Configure\Edit\Line_Dialer
	Auto Redial allows repeated automatic dial backup attempts by			(DTR Auto Redial)
	specifying the range of Directory Locations that can be tried. A redial
	attempt is made in response to a bad phone number, a busy signal, no
	answer, or no quiet answer. The modem must be in Originate mode.
	When DTE Dialer Type is DTR=Dirs, Auto Redial works in conjunction
	with the DTR Cont Repeat (S38) configuration option.
	Register has the following values:
	S37 = 0 Use Directory Location 1
	S37 = 1 Use Directory Locations 1–2
	S37 = 2 Use Directory Locations 1–3
	S37 = 3 Use Directory Locations 1–4
	S	S	S
	S	S	S
	S37 = 9 Use Directory Locations 1–10
	NOTE: The modem must be in Originate mode to perform an automatic
	dial backup.
S38	DTR Cont Repeat			Configure\Edit\DTE_Dialer
	Determines whether automatic dialing of dial backup directory locations
	will be repeated continuously, or halted after the first pass.
	Regardless of the setting of S38, dialing is locked out after ten failed
	attempts to connect to the same number.
	Register has the following values:
	0 = Disable
	1 = Enable
	Factory setting is Disable.

14-18 September 1998 3810-A2-GB30-30