Paradyne 3800 manual Test Branch, Abort, Self, AT Command Equivalent

COMSPHERE 3800 Series Modems

Test Branch

To access the Test branch from the Top-Level menu, make the following selections:

Idle : 19.2

Status Test

F1 F2 F3

Press the key until Test appears. Select Test.

Abort

Abort ends any test that is in progress and brings the modem back to the normal mode of operation. Confirmation is provided by the Command Complete message.

Test :		>
Abort		Self
F1	F2	F3

Select Abort.

Test : Abort

Command Complete

F1 F2 F3

The modem stops all tests currently in progress and displays the Command Complete status message on the LCD. To exit this function and remain in the Test branch,

press the key. To exit and return to the Top-Level

menu, press the key.

AT Command Equivalent

The AT command is &T0.

Self

Self performs an internal self-test of the modem, which takes less than a minute to complete. The modem must be offline (not connected with another modem), otherwise Invalid Command appears. This test is not valid in Remote mode and does not appear on the LCD of either modem when in Remote mode.

To access Self from the Test branch, make the following selection:

Test :		>
Abort		Self
F1	F2	F3

Select Self. (All LCD cells and DCP status indicators light.)

If the modem passes self-test, Pass appears on the LCD. If it fails, Failed appears. If the modem fails, contact your service representative.

If Invalid Command appears on the LCD, then another test is in progress or the modem is operating on dial lines. Select Abort to clear the current test, or disconnect to clear the dial lines, and then choose Self.

If the modem receives a ring signal during this test, the test is cancelled and the RI Abort message appears.

To exit this function and remain in the Test branch,

press the key. To exit and return to the Top-Level

menu, press the key.

AT Command Equivalent

The AT command is &T9.

8-2 September 1998 3810-A2-GB30-30