Paradyne 3800 12 of, Series AT Commands, Description, Front Panel, Branch, MNP5 Data Compression

COMSPHERE 3800 Series Modems

					Table 14-1
					(12 of 12)
					3800 Series AT Commands
AT					Description	Front Panel
Command						Branch
%Bn (cont’d)	Modulation and Data Rate can also be set using S-register S41. The following
	table shows the equivalent values of S41 for each %Bn value, and, where
	applicable, %Bn in combination with Bn.
	S41	= 20		%B19200	V.32terbo, 19,200 bps
	S41	= 21		%B16800	V.32terbo, 16,800 bps
	S41	= 1		%B14400	V.32bis, 14,400 bps
	S41	= 2		%B12000	V.32bis, 12,000 bps
	S41	= 3		%B9600	V.32bis/V.32, 9600 bps
	S41	= 4		%B7200	V.32bis, 7200 bps
	S41	= 5		%B4800	V.32bis/V.32, 4800 bps
	S41	= 6		%B2400	V.22bis. 2400 bps
	S41	= 7		%B1200/B0	V.22, 1200 bps
	S41	= 8		%B1200/B1	Bell 212A, 1200 bps
	S41	= 10		%B300/B0	V.21, 300 bps
	S41	= 11		%B300/B1	Bell 103J, 300 bps
	The factory default is %B19200.
%Cn	MNP5 Data Compression					Configure\Edit\
	%C0		Disable.			V42/MNP/Buffer
	%C1		Enable.
%Rn	DTE Rate					Configure\Edit\
	Sets the rate at which data is passed between the modem and the DTE.					DTE Interface
	%R must be the last command on the command line. Setting the DTE rate with
	the %R command does not turn off autobauding.
	%R115200			Sets the DTE rate to 115,200 bps.
	%R76800			Sets the DTE rate to 76,800 bps.
	%R57600			Sets the DTE rate to 57,600 bps.
	%R38400			Sets the DTE rate to 38,400 bps.
	%R19200			Sets the DTE rate to 19,200 bps.
	%R14400			Sets the DTE rate to 14,400 bps.
	%R9600			Sets the DTE rate to 9600 bps.
	%R7200			Sets the DTE rate to 7200 bps.
	%R4800			Sets the DTE rate to 4800 bps.
	%R2400			Sets the DTE rate to 2400 bps.
	%R1200			Sets the DTE rate to 1200 bps.
	%R300			Sets the DTE rate to 300 bps.
″ Hn	V.42bis Data Compression					Configure\Edit\
	″ H0		Disable.			V42/MNP/Buffer
	″ H1		Transmit only.
	″ H2		Receive only.
	″ H3		Transmit and Receive.

14-14 September 1998 3810-A2-GB30-30