Paradyne 12 of 3800 Series S-Registers, Description, Front Panel Branch, DTE Rate = VF Rate

COMSPHERE 3800 Series Modems

S-Register

Table 14-2

(12 of 12)

3800 Series S-Registers

Description Front Panel Branch

S89	V.42 ARQ Window Size Increase		None
	Register allows the V.42 Automatic Request for Transmission (ARQ)
	window size to be set to a value from 6 to 15 frames to accommodate
	satellite delays.
	Register has the following values:
	0 for 6 frames (default)
	1 for 7 frames
	2 for 8 frames
	3 for 9 frames
	S	S
	S	S
	9 for 15 frames
	This command applies only to connections made using V.42bis data
	compression or V.42 error control.
	Factory setting is 6 frames.
S90	DTE Rate = VF Rate		Configure\Edit\Misc
	Register forces the DTE (computer) data rate to be equal to the VF
	(telephone line) data rate.
	Register has the following values:
	0 = Disable
	1 = Enable
	Factory setting is Disable.
S91	Cellular Enhancements		Configure\Edit\Misc
	Register determines whether parameters are set to improve performance
	over a cellular link. Should be enabled when the remote modem is using
	a cellular connection.
	Register has the following values:
	0 = Disable
	1 = Enable
	Factory setting is Disable.
S92	V.29 Train On Data		Configure\Edit\Leased Line
	Valid only if the V.29 Option is installed, and effective only if V.29 is
	selected for the leased-line rate. Register determines whether the
	modem must receive a standard V.29 training sequence in order to enter
	Data mode (Disable) or whether it should use the received Data mode
	for training (Enable).
	Register has the following values:
	0=Disable
	1=Enable
	Factory setting is Disable.
S93	RJ11 Cellular Adapt		Configure\Edit\Misc
	Valid only if Enhanced Throughput Cellular (ETC) is installed. Register
	controls support for an RJ11 connection, including generation of the ETC
	1.1 Calling Tone during call origination.
	Register has the following values:
	0 = Disable
	1 = Enable
	Factory setting is Disable.

14-26 September 1998 3810-A2-GB30-30