Paradyne 9 of 3800 Series S-Registers, Description, Front Panel Branch, NMS Call Messages

AT Command Set and S-Registers

S-Register

Table 14-2

(9 of 12)

3800 Series S-Registers

Description Front Panel Branch

S64

V.25bis New Line Character

Register identifies to the modem the type of line terminator used by the DTE while in V.25bis mode.

Register has the following values:

0 = Carriage Return and Line Feed

1 = Carriage Return

2 = Line Feed

Factory setting is carriage return and line feed (CR + LF).

Configure\Edit\DTE Dialer

S65	Line Current Disconnect		Configure\Edit\Line Dialer
	Register determines if the modem disconnects if an 8-millisecond or
	90-millisecond interruption in loop current occurs.
	Register has the following values:
	0	= Enable (8msec)
	1	= Enable (90msec)
	2	= Disable
	Factory setting is Enable (8msec).
S66	NMS Call Messages		Configure\Edit\Misc
	Register determines if the modem sends information regarding status
	(Call Progress) and/or sends summarized call statistics (Call Connect) to
	the network management system (COMSPHERE 6700 Series NMS).
	Register has the following values:
	0	= Call Connect & Progress
	1	= Disable
	2	= Call Connect Only
	3	= Call Progress Only
	Factory setting is Call Connect & Progress.
S67	Directory Location 1 Callback		Configure\Edit\Misc
	Register determines if the modem uses the single number callback
	function.
	Register has the following values:
	0	= Disable
	1	= Enable
	Factory setting is Disable.
S69	Make Busy Via DTR		Configure\Edit\Line Dialer
	Register determines if the modem goes off-hook (busy) when DTR is Off.
	Register has the following values:
	0	= Disable
	1	= Enable
	Factory setting is Disable.
S74	Network Position Identification		Configure\Edit\Misc
	Register identifies each modem as either a control or tributary modem.
	Register has the following values:
	0	= Tributary
	1	= Control
	Factory setting is Tributary.

3810-A2-GB30-30 September 1998 14-23