Paradyne 3800 manual Removing and Replacing Model 3810 and Model 3820 Modems

COMSPHERE 3800 Series Modems

Removing and Replacing

Model 3810 and

Model 3820 Modems

To remove and replace a Model 3810 or Model 3820 modem, perform the following steps:

1.Make sure the modem is offline, and press the modem’s rear panel power switch to the Off position.

2.Disconnect the power cord from the ac power outlet, and then from the connector on the rear of the modem.

3.Disconnect the dial and leased-line modular cords from the modem’s rear panel.

4.Disconnect the DTE interface cable from the modem’s rear panel.

If the modem is to be removed for service, return it using the procedures on page A in the front of this document for contact information.

5.Install the replacement modem as described in the Model 3810 or Model 3820 Modem Installation section of this chapter, and configure it the same way as the modem being replaced.

2-8 September 1998 3810-A2-GB30-30