Paradyne manual 11 of 3800 Series S-Registers, Description, Front Panel Branch, AT Command Mode

AT Command Set and S-Registers

S-Register

Table 14-2

(11 of 12)

3800 Series S-Registers

Description Front Panel Branch

S81	2W Leased Line SQ Retrain		Configure\Edit\Leased Line
	Forces the modem to retrain if the SQ (Signal Quality) LED is on for
	more than the specified number of seconds (1–5). 2W SQ Retrain
	reduces the amount of bad data sent to the DTE when no error control is
	used, but greatly increases the likelihood of retrains on impaired lines.
	Register has the following values:
	0	= Disable
	1–5 = Retrain is initiated after this number of seconds of SQ problems
	Factory setting is Disable.
S82	V.32bis Autorate (Leased Line)		Configure\Edit\Leased Line
	Register determines if Autorating is used on leased lines when
	connected in V.32bis mode.
	Register has the following values:
	0	= Enable
	1	= Disable
	Factory setting is Enable.
S84	AT Command Mode		Configure\Edit\DTE Dialer
	Register determines how the modem responds to valid and invalid AT
	commands.
	Register has the following values:
	0	= Normal
	1	= No ERROR
	2	= No Strap or ERROR
	Factory setting is Normal.
S85	Fast Disconnect		Configure\Edit\Line Dialer
	Register allows the modem to disconnect immediately after receiving a
	disconnect command from a local DTE or its own diagnostic control
	panel.
	Register has the following values:
	0	= Disable
	1	= Enable
	Factory setting is Disable.
S88	Straps When Disconnected		Configure\Edit\V.42/MNP/
	Register determines whether the Active(Operating) area is reloaded		Buffer
	upon a disconnect.
	Register has the following values:
	0	(or 231) = No Change
	1	(or 232) = Reload
	2	(or 233) = Reload with no AT Change
	Factory setting is No Change.

3810-A2-GB30-30 September 1998 14-25