Paradyne 2 of 3800 Series S-Registers, Description, Front Panel Branch, Line Feed Character

COMSPHERE 3800 Series Modems

S-Register

Table 14-2

(2 of 12)

3800 Series S-Registers

Description Front Panel Branch

S4	Line Feed Character	Configure\Edit\DTE Dialer
	Register determines ASCII value used as the line feed character.
	Enter a value from 0 to 127 for the line feed character.
	Factory setting is 10 (ASCII carriage return or line feed).
S5	Backspace Character	Configure\Edit\DTE Dialer
	Register determines ASCII value used as the backspace (Backspace
	key). This character moves the cursor to the left and erases the previous
	character.
	Enter a value from 0 to 127.
	Factory setting is 08 (backspace key).
S6	Blind Dial Pause	Configure\Edit\Line Dialer
	Register determines how long (in seconds) the modem waits after going
	off-hook before dialing a telephone number if using result code X0, X1,
	or X3.
	Enter a value from 2 to 255 seconds.
	Factory setting is 2 seconds.
S7	No Answer Timeout	Configure\Edit\Line Dialer
	Register determines how long (in seconds) an originating modem waits
	before abandoning a call when no answer tone is received.
	Enter a value from 1 to 255 seconds.
	Factory setting is 45 seconds.
S8	‘‘,” Pause Time for the Dial Modifier	Configure\Edit\Line Dialer
	Register determines how long (in seconds) the modem pauses when it
	encounters a comma (,) in the Dial command string.
	Enter a value from 0 to 255 seconds.
	Factory setting is 2 seconds.
S10	No Carrier Disconnect	Configure\Edit\Line Dialer
	Register determines how long (in tenths of seconds) the modem allows
	the carrier signal to be off before disconnecting the call.
	Enter a value from 0 to 254 in 0.1 second increments. (A value of 255
	disables this register.)
	Factory setting is 20 (2 seconds).
S12	Escape Guard Time	Configure\Edit\DTE Dialer
	Register sets the value (in 20-millisecond increments) for the required
	pause before and after the escape sequence is issued. The guard time
	prevents the modem from interpreting data as the escape sequence
	characters.
	Enter a value from 0 to 255 in 20-millisecond increments. For example,
	the factory setting of 50 equals 1000 milliseconds or one second.
	Factory setting is 50 (1 second).

14-16 September 1998 3810-A2-GB30-30