2571

By default, the delay signal duration is 400 milliseconds.

Related command: em-signal.

Example # Set the delay signal duration in the delay start mode to 500 seconds.

<Sysname> system-view [Sysname] voice-setup [Sysname-voice] subscriber-line 1/0 [Sysname-voice-line1/0] em-signal delay

[Sysname-voice-line1/0] delay hold 500

delay rising

Syntax delay rising milliseconds

undo delay rising

View E&M voice subscriber line view

Parameter rising milliseconds: Specifies delay time (in milliseconds) from when the terminating side detects a seizure signal to when it sends a delay signal in the delay start mode. The value ranges from 20 to 2,000.

Description Use the delay rising command to configure a delay time from when the terminating side detects a seizure signal to when it sends a delay signal in the delay start mode.

Use the undo delay rising command to restore the default.

By default, the delay time is 300 milliseconds.

Related command: em-signal.

Example # Set the delay time from when the terminating side detects a seizure signal to when it sends a delay signal in the delay start mode to 700 milliseconds.

<Sysname> system-view [Sysname] voice-setup [Sysname-voice] subscriber-line 1/0 [Sysname-voice-line1/0] em-signal delay

[Sysname-voice-line1/0] delay rising 700

delay send-dtmf

Syntax delay send-dtmf milliseconds

undo delay send-dtmf

View E&M voice subscriber line view

Page 2571
Image 2571
3Com MSR 50 Delay rising, Delay send-dtmf, Related command em-signal, Syntax delay rising milliseconds Undo delay rising