3Com MSR 30, MSR 50 Primary authorization, Reset hwtacacs statistics, Undo primary authorization

1982 CHAPTER 129: HWTACACS CONFIGURATION COMMANDS

primary authorization

Syntax primary authorization ip-address [ port-number ]

undo primary authorization

View HWTACACS scheme view

Parameter ip-address: IP address of the server, a valid unicast address in dotted decimal notation. The default is 0.0.0.0.

port-number: Port number of the server. It ranges from 1 to 65535 and defaults to 49.

Description Use the primary authorization command to specify the primary HWTACACS authorization server.

Use the undo primary authorization command to remove the configuration.

Note that:

■The IP addresses of the primary and secondary authorization servers cannot be the same. Otherwise, the configuration fails.

■The HWTACACS service port configured on the device and that of the HWTACACS server must be consistent.

■If you configure the command for more than one time, the last configuration takes effect.

■You can remove an authorization server only when no active TCP connection for sending authorization packets is using it.

Related command: display hwtacacs.

Example # Configure the primary authorization server.

<Sysname> system-view

[Sysname] hwtacacs scheme hwt1

[Sysname-hwtacacs-hwt1] primary authorization 10.163.155.13 49

reset hwtacacs statistics

Syntax	reset hwtacacs statistics { accounting all authentication authorization }
View	User view
Parameter	accounting: Clears HWTACACS accounting statistics.
	all: Clears all HWTACACS statistics.