3Com MSR 30, MSR 50 manual Call-mode, Cid select-mode, Related command Trunk-idand address Example

2712 CHAPTER 179: VOFR CONFIGURATION COMMANDS

	[Sysname-voice-dial] entity 4 vofr
	[Sysname-voice-dial-entity4] match-template 12345
	[Sysname-voice-dial-entity4] address vofr-dynamic serial1/0 100
call-mode
Syntax	call-mode { dynamic static }
	undo call-mode
View	VoFR entity view
Parameter	dynamic: Adopts the dynamic call mode.
	static: Adopts the FRF.11 trunk mode.
Description	Use the call-modecommand to configure the mode in which calls between the
	VoFR entity and the peer voice entity are established.
	Use the undo call-modecommand to restore the default call mode.
	By default, the dynamic mode is adopted.
n	■ Dynamic call mode: When a call is originated, the frame relay will randomly
	select an idle FRF.11 sub-channel to establish a voice channel. After the call is
	completed, the frame relay will immediately remove the voice channel and
	release the corresponding FRF.11 sub-channel. The call control protocol used in
	the dynamic call mode is specified by executing the vofr command in interface
	DLCI view.
	■ FRF.11 trunk mode: A voice channel is established when you execute the
	address vofr-staticcommand. The voice channel is directly used to establish
	calls. After the call is completed, the voice channel remains until it is manually
	cleared. In the FRF.11 trunk mode, you must use the trunk-idcommand to
	configure a PSTN-dialed number for the terminating VoFR entity.
Related command:	trunk-idand address.
Example	# Configure the FRF,11 trunk mode for VoFR entity 10.
	<Sysname> system-view
	[Sysname] voice-setup
	[Sysname-voice] dial-program
	[Sysname-voice-dial] entity 10 vofr
	[Sysname-voice-dial-entity10] call-mode static
cid select-mode
Syntax	cid select-mode { max-poll min-poll }
	undo cid select-mode