3Com MSR 30, MSR 50 manual Display connection-limit statistics

2018 CHAPTER 133: NAT CONFIGURATION COMMANDS

Table 521 Description on the fields of the display connection-limit policy all command

Field	Description
limit	Number of rules in the policy
limit mode	Connection-limit mode (all, amount, rate):
	■ all: limits both connection number and connection rate.
	■ amount: limits connection number only.
	■ rate: limits connection rate only.
limit rate	Connection rate limit
acl	Access control list
per-source	Statistics based on the source addresses in the ACL
amount	Upper and lower limits of connections

display connection-limit statistics

Syntax display connection-limit[ destination dst-address range } port-number ] [

statistics [ source src-address { mask mask-length } ]

{mask mask-length } ] [ destination-port{ eq gt lt neq vpn-instancevpn-instance-name ]

View	Any view
Parameter	source src-address: Displays the connection-limit statistics for the specified source
	address.
	destination dst-address: Displays the connection-limit statistics for the specified
	destination address.
	mask: Network mask.
	mask-length: Mask length, in the range 1 to 32.
	destination-port { eq gt lt neq range } port-number: Displays
	connection-limit statistics based on the destination port number. You can specify
	the port(s) in different ways through different keywords: eq (equal to the specified
	port number), gt (greater than the specified port number), lt (less than the
	specified port number), neq (not equal to the specified port number), range (in a
	port range). The value range of port-numberis 0 to 65,535. The value range of
	start-portand end-portis also 0 to 65,535, and the start-portmust be not greater
	than the end-port.
	vpn-instancevpn-instance-name: Specifies the MPLS VPN instance that a
	connection belongs to. The vpn-instance-nameargument ranges from 1 to 19
	characters. Absence of this keyword and argument indicates that the user whose
	connection statistics are to be displayed belongs to a normal private network
	rather than an MPLS VPN instance.
Description	Use the display connection-limit statistics command to display
	connection-limit statistics.