3Com MSR 30, MSR 50 manual Isdn ignore sending-complete incoming outgoing, Configured

576CHAPTER 37: ISDN CONFIGURATION COMMANDS

Example # Disable ISDN to carry the LLC information element in the SETUP messages for the voice calls placed on the interface BRI 1/0.

<Sysname> system-view

[Sysname] interface bri 1/0

[Sysname-Bri1/0] isdn ignore llc

isdn ignore sending-complete

Syntax	isdn ignore sending-complete [ incoming outgoing ]
	undo isdn ignore sending-complete [ incoming outgoing ]
View	ISDN interface view
Parameter	incoming: Ignores the Sending Complete Information Element in Setup messages
	when receiving a call.
	outgoing: Sends Setup messages without the Sending Complete Information
	Element when placing a call.
Description	Use the isdn ignore sending-completecommand to configure the ISDN
	protocol to ignore the Sending Complete Information Element in Setup messages
	when receiving a call, or to send Setup messages without the Sending Complete
	Information Element when placing a call.
	Use the undo isdn ignore sending-completecommand to restore the default
	setting.
	As for the data exchange performed between a router and an ISDN switch, the
	default is as follows.
	■ For an incoming call, the router checks the received Setup messages for the
	Sending Complete Information Element to determine whether or not the
	number is received completely. If a Setup message does contain the Sending
	Complete Information Element, the number is not received completely.
	■ For outgoing calls, a Setup message containing the Sending Complete
	Information Element indicates that the number is sent completely.
	If you execute the isdn ignore sending-completecommand with no keyword
	specified, the Sending Complete Information Element-related operations are
	performed when a router receives a call or places a call.
n	■ In the event that the router is communicating with an ISDN exchange, its
	settings must be the same as those on the exchange.
	■ Only with DSS1, QSIG or ETSI on interface ISDN protocol can this command be
	configured.
	You are not allowed to configure this command on an ISDN interface if there is still
	a call on it. This command can take effect only if it is configured when there is no
	call on the interface. Alternatively, you can manually disable the interface by