Tandberg Data VXA-320 (VXA-3) manual Side mounting

INSTALLING THE TAPE DRIVE

Using the screws provided with the tape drive, secure the tape drive in the drive bay using one of the screw mounting combinations (see Figure 2-5).

Caution To avoid damaging the tape drive, follow these precautions:

Use only the M3 ⋅ 0.5 ⋅ 5 mm Phillips screws. Screw length must not exceed 5mm.

Ensure that the chassis is not distorted. (Alignment to the horizontal or vertical plane should not exceed ±10°.)

Ensure that no objects (screw heads, cables, or adjacent devices) are pressing against the frame.

Do not use a combination of the two sets of mounting holes. Do not obstruct the ventilation fan on the back of the tape drive.

Side mounting Bottom mounting

3

3

Figure 2-5Screw mounting configurations (internal model)

3.Power on the computer system or enclosure.

During the tape drive’s power-on self-test, the LEDs scroll sequentially right to left, then left to right in amber and green. LED 4 illuminates in red and green. When POST is complete, LED 4 illuminates in green. (See Table 3-1, “LED states,” on page 20 for a description of the LED states.)

OCTOBER 2006 VXA-320 TAPE DRIVE

13