Tandberg Data VXA-320 (VXA-3) manual Prepare the drive bay

CHAPTER 2 INSTALLATION

2.Prepare the drive bay.

Remove the drive bay’s cover plate according to the system manufacturer’s instructions.

3.Set the SCSI ID jumpers, if necessary.

a.The tape drive is shipped with a SCSI ID of 11. If another device on the SCSI bus is already configured with this SCSI ID, you will need to change the tape drive’s SCSI ID. Reposition the jumpers on the jumper block, as shown in Figure 2-2, to select the desired ID. (If necessary, use flat-nose pliers to remove the jumpers.) If you need an additional jumper, use a 2 mm jumper.

Address 0	Address 1	Address 8	Address 9
			Factory
			setting
Address 2	Address 3	Address 10	Address 11
Address 4	Address 5	Address 12	Address 13
Address 6	Address 7	Address 14	Address 15

Figure 2-2SCSI ID settings

Alternatively, you can remove the jumpers and connect a cable (not included) from a remote switch to the jumper block, then use the remote switch to set the SCSI ID. The cable should use a connector equivalent to Hirose Housing part number DF11-8DS-2C, 2.0MM 8CKT to connect to the jumper block.

!Important Each device on the SCSI bus must have a unique SCSI ID.

b.Provide additional grounding, if desired.

Attaching the tape drive to the enclosure protects the tape drive from ESD. However, if you want additional chassis grounding for the tape drive, use the grounding hole or grounding tab on the back panel (see Figure 2-1):

10

PRODUCT MANUAL 433689-01