Tandberg Data VXA-320 (VXA-3) Back Panel Components – Internal Tape Drive, VXA-320TAPE DRIVE

COMPONENTS

Status LEDs (Light Emitting Diodes) Show status information, which is described in “Monitoring the LEDs” on page 20.

Power LED Shows the power-on status of the external tape drive.

BACK PANEL COMPONENTS – INTERNAL TAPE DRIVE

Figure 1-4shows the back panel components of the internal SCSI tape drive. For more information about using these components during installation, see Chapter 2.

	SCSI	Auxiliary
Fan	connector	connector

Grounding tab

SCSI ID jumper block

Grounding		Power
	RF service
hole	connector	connector

Figure 1-4Internal tape drive: back-panel components

Fan Provides cooling to maintain proper operating temperature at the tape path.

SCSI Connector Used to connect the tape drive to the SCSI bus. This is a 68-pin LVD SCSI connector. (See Table 6-4for pin assignments.)

Auxiliary Connector Used for tape drive diagnostics.

SCSI ID Jumper Block (SCSI model only) Used to set the SCSI ID.

Grounding Tab and Hole Used to provide additional chassis grounding. (The mounting screws also provide grounding for the tape drive.)

RF Service Connector Reserved for Tandberg Data Service personnel.

Power Connector Used to connect a power cable from the enclosure’s power supply. This is a 4-pin connector. (See Table 6-4for pin assignments.)

OCTOBER 2006 VXA-320 TAPE DRIVE

3