Extron electronic 450 Plus Series manual Command, Response Additional description

Programmer’s Guide, cont’d

Command/response table for SIS commands (Cont’d)

Command	ASCII Command			Response		Additional description
	(host to switcher)			(switcher to host)
View ties, gain, volume, mutes, presets, and DSVP
View RGBHV output tie		X3	&		X2
Example:	15&			27		Input 27 RGBHV tied to output
						15.
View video output tie			%
		X3			X2
Example:	7%			02		Input 2 video tied to output 7.
View audio output tie		X3	$		X2
Example:	3$			06		Input 6 audio tied to output 3.
View input gain			G
		X2			X4
Example:	4G			-02		Gain for input #4 is -2 dB.
View output volume		X2	V		X7
Example:	7V			55		Volume for output #7 is 55 steps
						(9 dB of attenuation / 86.5% of
						total volume).

View output mutes

	VM	Mut		1		2...		n	Each		response is the mute
Esc			X14		X14		X14			X14
									status of an output, starting from
									output 1, n is the maximum
									number of outputs for this
									model.

Example:

(CrossPoint 450 Plus 3232 HVA)

Esc	VM	M u t 0 0 0 0 1 0 0 0 0 0 0 2 3 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
		Output 5 video is muted, output
		12 audio is muted, and output 13
		video and audio are muted. All
		other outputs are unmuted.

The MUT portion of the response appears only when the switcher is in Verbose mode 3. See the

Verbose mode command on page 4-19.

View video global preset configuration EscX11 * X3 *1VC

X2 1• X2 2• X2 3•...• X2 16•Vid Show preset X11 ’s video

														configuration. Show the video
														input tied to 16 sequential
														outputs, starting from output									.
																						X3
Command description:	preset#*starting output# (StO#)*1(=video)VC
Response description:	input # (I#) assigned to StO#•I# assigned to StO#+1...I# assigned to StO#+15•Vid
Example:			4*17*1VC
		Esc
			input 24 tied to output 19								no tied input				input 8 tied to output 29
	Response = tied input:
							08•08•24•08•08•29•29•00•08•01•01•01•08•08•08•08•Vid
			Output:	17	18	19		20	21	22		23	24	25	26	27	28	29	30	31	32

The starting output # (StO#) should always be 1 for matrix sizes of 16 outputs or smaller.

EscX11 * X3 *1VC where

X11 = 0 returns the switcher’s current video configuration.

Each position shown in the response is an output: left = starting, right= starting output +15. The number in each position is the input tied to that output.

Video — Input 1 is tied to outputs 26 through 28; input 8 to outputs 17, 18, 20,21, 25, and 29 through 32; input 24 to output 19; and input 29 to outputs 22 and 23. No input is tied to output 24.

4-14 CrossPoint 450 Plus and MAV Plus Switchers • Programmer’s Guide