Extron electronic 450 Plus Series manual Hard reset

The hard reset restores the factory-installed firmware. The switcher reverts to that factory firmware the next time power is cycled off and on unless a firmware update is performed before the power cycle.

1.	If necessary, turn off power to the switcher.
2.	Press and hold the Reset button on the rear panel while you apply AC power
	to the switcher (figure 3-83).
	Press and hold the Reset button while
	you apply power to the switcher.
	RESET

The switcher flashes the front panel button indicators green, red, and amber and then turns them off.

Power

Continue to hold the Reset button until all input and output buttons return to either unlit or to background illumination and the RGBHV or Video and Audio buttons turn on.

Release the Reset button.

RESET

NOTE The Reset button on switchers with matrix sizes of 24 x 12 and above have a different appearance and do not have a rear panel Reset LED.

Figure 3-83 — Hard reset

CrossPoint 450 Plus and MAV Plus Switchers • Operation 3-55