Extron electronic 450 Plus Series manual Performing a hard reset, Reset

Operation, cont’d

1. Press and hold the Reset button until the front panel RGBHV (CrossPoint 450 Plus)/Video (MAV Plus) and Audio buttons blink once (events reset), twice (system reset), or three times (absolute reset) (figure 3-82).

Press and hold the Reset button.

Events Reset RESET

Reset LED flashes once.

3 seconds RESET

Release, then immediately press and release again.

RESET

Front panel I/O buttons flash once.

I / O

RGBHV AUDIO

Press and hold	Reset LED flashes twice.
the Reset button.

IP Settings	RESET	6 seconds	RESET
Reset

Release, then immediately press and release again.

RESET

Front panel I/O buttons flash twice.

I / O

RGBHV AUDIO

Press and hold the Reset button.

Absolute Reset RESET

Reset LED flashes

three times.

9 seconds RESET

Release, then immediately press and release again.

RESET

Front panel I/O buttons flash three times.

I / O

RGBHV AUDIO

NOTE The Reset button on switchers with matrix sizes of 24 x 12 and above have a different appearance and do not have a rear panel Reset LED.

Figure 3-82 — Whole switcher and absolute resets

2.	Release the Reset button and then immediately press and hold the Reset
	button until the LED flashes three times. Release the Reset button. Nothing
	happens if the second momentary press does not occur within 1 second.

Performing a hard reset

The hard reset function restores the switcher to the base firmware that it shipped with. After a hard reset, events do not automatically start, but user settings and files are restored. Perform a hard reset as follows:

3-54 CrossPoint 450 Plus and MAV Plus Switchers • Operation