Extron electronic 450 Plus Series manual Programmer’ser’sGuide,Guidecont’d, Serial Ports

Programmer’ser’sGuide,Guidecont’d

Serial Ports

The switcher has one or two serial ports that can be connected to a host device such as a computer running the HyperTerminal utility, an RS-232 capable PDA, or a control system. These ports make serial control of the switcher possible. The serial ports are:

•The rear panel Remote (RS-232 or RS-422) port, a 9-pin D female connector

•The front panel Configuration (RS-232) port, a 2.5 mm mini stereo jack (matrix sizes up to 1616 only)

The default protocol for both ports is as follows:

•	9600 baud	•	no parity	• 8 data bits
•	1 stop bit	•	no flow control

The ports can be configured to operate at the 9600, 19200, 38400, or 115200 baud rate.

These two ports are independent of one another. A front panel Configuration port connection and a rear panel Remote port connection can both be active at the same time.

The switcher can operate at 9600, 19200, 38400, or 115200 baud rates, but

Extron recommends leaving these ports at 9600 baud only.

Rear panel Remote port

REMOTE

						84 through 1616		2412 through 3232
				All Models		Matrix Sizes		Matrix Sizes
			Pin	RS-232	Function	RS-422	Function	RS-422	Function
1		RS232/RS422	1	—	Not used	—	Not used	TX+	Transmit data (+)
	6		2	TX	Transmit data	TX–	Transmit data (–)	TX–	Transmit data (–)
			3	RX	Receive data	RX–	Receive data (–)	RX+	Receive data (+)
5	9		4	—	Not used	—	Not used	RX–	Receive data (–)
			5	Gnd	Signal ground	Gnd	Signal ground	Gnd	Signal Ground
			6	—	Not used	—	Not used	—	Not used
			7	—	Not used	RX+	Receive data (+)	—	Not used
			8	—	Not used	TX+	Transmit data (+)	—	Not used
			9	—	Not used	—	Not used	—	Not used

Figure 4-1 — Remote connector pin assignments

The rear panel Remote port can support either RS-232 or RS-422 serial communication protocol, and can operate at 9600, 19200, 38400, or 115200 baud rates. See “Selecting the rear panel Remote port protocol and baud rate” in chapter 3, “Operation”, to configure the rear panel Remote port from the front panel.

4-2 CrossPoint 450 Plus and MAV Plus Switchers • Programmer’s Guide