Extron electronic 450 Plus Series manual File Management, Firmware

2.	Connect the PC to the CrossPoint 450 Plus or MAV Plus switcher via the
	switcher’s Ethernet port.
3.	Access the CrossPoint 450 Plus or MAV Plus switcher using HTML pages.
4.	Click the Configuration tab.
5.	Click the Firmware Upgrade link.
6.	Click the Browse button. An open file window appears.
7.	Navigate to the folder where you saved the firmware upgrade file. Select the
	file.
		Valid firmware files must have the file extension ‘.S19’. Any other file
		extension is not a firmware upgrade.
		The original factory-installed firmware is permanently available on the
		CrossPoint 450 Plus or MAV Plus switcher. If the attempted firmware upload
		fails for any reason, the switcher automatically reverts to the factory-installed
		firmware.
8.	Click the Open button.
9.	Click the Upload button. The firmware upload to the CrossPoint 450 Plus or
	MAV Plus switcher may take a few minutes.

File Management Page

To delete files such as HTML pages from the switcher or to upload your own files to the switcher, click the File Management tab. The switcher downloads the file management HTML page (figure 6-9).

Refresh.

Figure 6-9 — File Management page

The files listed in figure 6-9 are shown for example only and may not be present on your switcher.

To delete a file, check the associated delete check box and click the Delete Files button.

CrossPoint 450 Plus and MAV Plus Switchers • HTML Operation 6-11