ProSecure Unified Threat Management (UTM) Appliance

Tip: If you arrange with your ISP to have more than one public IP address for

your use, you can use the additional public IP addresses to map to servers on your LAN or DMZ. One of these public IP addresses is used as the primary IP address of the router that provides Internet access to your LAN computers through NAT. The other addresses are available to map to your servers.

To configure the UTM for additional IP addresses:

1.Select Network Security > Firewall. The Firewall submenu tabs display.

2.If your server is to be on your LAN, click the LAN WAN Rules submenu tab. (This is the screen used in this example). If your server is to be on your DMZ, click the DMZ WAN Rules submenu tab.

3.Click the Add table button under the Inbound Services table. The Add LAN WAN Inbound Service screen displays:

Figure 78.

4.From the Service drop-down list, select HTTP for a web server.

5.From the Action drop-down list, select ALLOW Always.

Firewall Protection

151

Page 151
Image 151
NETGEAR STM150EW-100NAS, UTM5EW-100NAS manual  To configure the UTM for additional IP addresses, 151