NETGEAR UTM5EW-100NAS, STM150EW-100NAS manual 280

ProSecure Unified Threat Management (UTM) Appliance

Figure 164.

b.Specify the default lifetimes in seconds:

•Authentication (IKE), Default. The default lifetime value is 3600 seconds. Change this setting to 28800 seconds to match the configuration of the UTM.

•Encryption (IPSec), Default. The default lifetime value is 1200 seconds. Change this setting to 3600 seconds to match the configuration of the UTM.

9.Click Apply to use the new settings immediately, and click Save to keep the settings for future use.

The VPN client configuration is now complete.

Instead of using the wizard on the VPN client, you can also manually configure the VPN client, which is explained in the following section.

Manually Create a Secure Connection Using the NETGEAR VPN Client

Note: Perform these tasks from a computer that has the NETGEAR

ProSafe VPN Client installed.

To configure a VPN connection between the VPN client and the UTM manually, create authentication settings (phase 1 settings), create an associated IPSec configuration (phase 2 settings), and then specify the global parameters.

Virtual Private Networking Using IPSec, PPTP, or L2TP Connections

280