NETGEAR UTM5EW-100NAS, STM150EW-100NAS manual Add Protocol Binding screen settings, 616

ProSecure Unified Threat Management (UTM) Appliance

•Destination Network. The Internet locations (based on their IP address) that are covered by the protocol binding rule.

•Action. The Edit button provides access to the Edit Protocol Binding screen for the corresponding service.

2.Click the Add table button below the Protocol Bindings table. The Add Protocol Binding screen displays:

Figure 355.

3.Configure the protocol binding settings as explained in the following table:

Table 156. Add Protocol Binding screen settings

Setting	Description
Service	From the drop-down list, select a service or application to be covered by this rule. If the
	service or application does not appear in the list, you need to define it using the Services
	screen (see Outbound Rules (Service Blocking) on page 129).
Local Gateway	From the drop-down list, select the DSL interface or one of the WAN interfaces.
Source Network	The source network settings determine which computers on your network are affected by
	this rule. Select one of the following options from the drop-down list:
	Any	All devices on your LAN.
	Single address	In the Start IP field, enter the IP address to which the rule is applied.
	Address Range	In the Start IP field and End IP field, enter the IP addresses for the
		range to which the rule is applied.
	Group 1–Group 8	If this option is selected, the rule is applied to the devices that are
		assigned to the selected group.
		Note: You can also assign a customized name to a group (see
		Change Group Names in the Network Database on page 115).

3G/4G Dongles for the UTM9S and UTM25S

616