NETGEAR UTM5EW-100NAS, STM150EW-100NAS manual Configure and Activate Firewall Logs, 476

ProSecure Unified Threat Management (UTM) Appliance

Configure and Activate Firewall Logs

You can configure the logging options for each network segment. For example, the UTM can log accepted packets for LAN-to-WAN traffic, dropped packets for WAN-to-DMZ traffic, and so on. You can also configure logging of packets from MAC addresses that match the source MAC address filter settings (see Enable Source MAC Filtering on page 179), and packets that are dropped because the session limit (see Set Session Limits on page 160), bandwidth limit (see Create Bandwidth Profiles on page 171), or both, have been exceeded.

Note: Enabling firewall logs might generate a significant volume of log messages. NETGEAR recommends that you enable firewall logs for debugging purposes only.

To configure and activate firewall logs:

1.Select Monitoring > Logs & Reports > Firewall Logs. The Firewall Logs screen displays:

Figure 276.

2.Enter the settings as explained in the following table:

Monitor System Access and Performance

476