NETGEAR STM150EW-100NAS, UTM5EW-100NAS manual List of VPN Policies table information, 301

ProSecure Unified Threat Management (UTM) Appliance

Figure 181.

Each policy contains the data that are explained in the following table. These fields are explained in more detail in Table 74 on page 304.

Table 73. List of VPN Policies table information

Setting	Description
! (Status)	Indicates whether the policy is enabled (green circle) or disabled (gray circle). To enable
	or disable a policy, select the check box next to the circle, and click the Enable or
	Disable table button, as appropriate.
Name	The name that identifies the VPN policy. When you use the VPN Wizard to create a VPN
	policy, the name of the VPN policy (and of the automatically created accompanying IKE
	policy) is the connection name.
Type	Auto or Manual as described previously (Auto is used during VPN Wizard configuration).
Local	IP address (either a single address, range of address, or subnet address) on your LAN.
	Traffic needs to be from (or to) these addresses to be covered by this policy. (The subnet
	address is supplied as the default IP address when you are using the VPN Wizard.)
Remote	IP address or address range of the remote network. Traffic needs to be to (or from) these
	addresses to be covered by this policy. (The VPN Wizard default requires the remote
	LAN IP address and subnet mask.)
Auth	The authentication algorithm that is used for the VPN tunnel. This setting needs to match
	the setting on the remote endpoint.
Encr	The encryption algorithm that is used for the VPN tunnel. This setting needs to match the
	setting on the remote endpoint.

Virtual Private Networking Using IPSec, PPTP, or L2TP Connections

301