NETGEAR STM150EW-100NAS, UTM5EW-100NAS Https//IPaddress or https//FullyQualifiedDomainName, 439

ProSecure Unified Threat Management (UTM) Appliance

2.Select one of the following radio buttons:

•Yes. Enable HTTPS remote management. This is the default setting.

•No. Disable HTTPS remote management.

WARNING:

If you are remotely connected to the UTM and you select the No radio button, you and all other SSL VPN users are disconnected when you click Apply.

3.As an option, you can change the default HTTPS port. The default port number is 443.

4.Click Apply to save your changes.

When remote management is enabled, you need to use an SSL connection to access the UTM from the Internet. You need to enter https:// (not http://) and type the UTM’s WAN IP address in your browser. For example, if the UTM’s WAN IP address is 10.16.0.123, type the following in your browser: https://10.16.0.123.

The UTM’s remote login URL is:

https://<IP_address> or https://<FullyQualifiedDomainName>

Note: For enhanced security, restrict access to as few external IP addresses as practical. See Set User Login Policies on page 404 for instructions about restricting administrator access by IP address.

Note: To maintain security, the UTM rejects a login that uses http://address rather than the SSL https://address.

Note: The first time that you remotely connect to the UTM with a browser through an SSL connection, you might get a warning message regarding the SSL certificate. If you are using a Windows computer with Internet Explorer 5.5 or later, simply click Yes to accept the certificate.

Network and System Management

439