ProSecure Unified Threat Management (UTM) Appliance

3.In the IKE SA Parameters section of the screen, locate the DPD fields, and complete the fields as explained the following table:

Table 83. Dead Peer Detection settings

Setting

Description

 

 

 

 

IKE SA Parameters

 

 

 

 

 

Enable Dead Peer

Select the Yes radio button to enable DPD. When the UTM detects an IKE

Detection

connection failure, it deletes the IPSec and IKE SA and forces a reestablishment

 

of the connection. You need to specify the detection period in the Detection

 

Period field and the maximum number of times that the UTM attempts to

 

reconnect in the Reconnect after failure count field.

 

 

 

 

Detection Period

The period in seconds between consecutive

 

 

DPD R-U-THERE messages, which are sent only when the

 

 

IPSec traffic is idle. The default setting is 10 seconds.

 

 

 

 

Reconnect after

The maximum number of DPD failures before the UTM tears

 

failure count

down the connection and then attempts to reconnect to the

 

 

peer. The default setting is 3 failures.

 

 

 

4.Click Apply to save your settings.

Configure NetBIOS Bridging with IPSec VPN

Windows networks use the Network Basic Input/Output System (NetBIOS) for several basic network services such as naming and neighborhood device discovery. Because VPN routers do not usually pass NetBIOS traffic, these network services do not function for hosts on opposite ends of a VPN connection. To solve this problem, you can configure the UTM to bridge NetBIOS traffic over the VPN tunnel.

To enable NetBIOS bridging on a configured VPN tunnel:

1.Select VPN > IPSec VPN > VPN Policies. The VPN Policies screen displays (see Figure 181 on page 301).

2.In the List of VPN Policies table, click the Edit table button to the right of the VPN policy that you want to edit. The Edit VPN Policy screen displays. (The following figure shows only the top part of a UTM50 screen with the General section).

Virtual Private Networking Using IPSec, PPTP, or L2TP Connections

330

Page 330
Image 330
NETGEAR UTM5EW-100NAS Configure NetBIOS Bridging with IPSec VPN,  To enable NetBIOS bridging on a configured VPN tunnel