NETGEAR UTM5EW-100NAS, STM150EW-100NAS manual Setup Wizard of 10 Email Notification

ProSecure Unified Threat Management (UTM) Appliance

Setup Wizard Step 8 of 10: Email Notification

Figure 33.

Enter the settings as explained in the following table, and then click Next to go the following screen.

Table 11. Setup Wizard Step 8: Email Notification screen settings

Setting	Description
Administrator Email Notification Settings
Show as mail sender	A descriptive name of the sender for email identification purposes. For example,
	enter UTM_Notifications@netgear.com.
SMTP server	The IP address and port number or Internet name and port number of your ISP’s
	outgoing email SMTP server. The default port number is 25.
	Note: If you leave this field blank, the UTM cannot send email notifications.
This server requires	If the SMTP server requires authentication, select the This server requires
authentication	authentication check box, and enter the user name and password.
	User name	The user name for SMTP server authentication.
	Password	The password for SMTP server authentication.
Send notifications to	The email address to which the notifications should be sent. Typically, this is the
	email address of the administrator.

After you have completed the steps in the Setup Wizard, you can change the administrator email notification settings by selecting Network Config > Email Notification. For more information about these settings, see Configure the Email Notification Server on page 466.

Use the Setup Wizard to Provision the UTM in Your Network

62