NETGEAR STM150EW-100NAS manual L2TP Server screen settings, 335, Setting Description L2TP Server

ProSecure Unified Threat Management (UTM) Appliance

Figure 201.

2.Enter the settings as explained in the following table:

Table 86. L2TP Server screen settings

Setting	Description
L2TP Server
Enable L2TP Server	To enable the L2TP server, select the Enable check box. Complete the following
	fields:
	Start IP Address	Type the first IP address of the address pool. This address
		is used for distribution to the UTM.
	End IP Address	Type the last IP address of the address pool. A maximum of
		six contiguous addresses can be part of the pool. (The first
		address of the pool cannot be assigned to a user.)
	User time out	Enter the time-out period in seconds, from 300 to 1800
		seconds. If there is no traffic from a user, the connection is
		disconnected after the specified period.

Authentication

Select one or more of the following authentication methods to authenticate L2TP users:

• PAP. RADIUS-Password Authentication Protocol (PAP).

• CHAP. RADIUS-Challenge Handshake Authentication Protocol (CHAP).

• MSCHAP. RADIUS-Microsoft CHAP (MSCHAP).

• MSCHAPv2. RADIUS-Microsoft CHAP version 2 (MSCHAPv2).

Note: For each authentication method that you want to use for L2TP users, you need to have created a domain that supports the authentication method (see Configure Domains on page 388) and have added the L2TP users to the domain (see Configure User Accounts on page 401).

3.Click Apply to save your settings.

Virtual Private Networking Using IPSec, PPTP, or L2TP Connections

335