NETGEAR STM150EW-100NAS, UTM5EW-100NAS manual 465, Setting Description When Limit is reached

ProSecure Unified Threat Management (UTM) Appliance

Table 114. WAN traffic meter settings (continued)

Setting	Description
When Limit is reached
Block Traffic	Select one of the following radio buttons to specify which action the UTM performs
	when the traffic limit has been reached:
	• Block All Traffic. All incoming and outgoing Internet and email traffic is
	blocked.
	• Block All Traffic Except E-Mail. All incoming and outgoing Internet traffic is
	blocked, but incoming and outgoing email traffic is still allowed.
Send e-mail alert	An email alert is sent when traffic is blocked. Ensure that emailing of logs is enabled
	on the Email and Syslog screen (see Configure and Activate System, Email, and
	Syslog Logs on page 467).

3.Click Apply to save your settings.

4.For the multiple WAN port models only, click the WAN2 Traffic Meter, WAN3 Traffic Meter (UTM150 only), or WAN4 Traffic Meter (UTM150 only) submenu tab to display the corresponding WAN Traffic Meter screen. These screens are identical to the WAN1 Traffic Meter screen (see Figure 271 on page 463).

5.For the multiple WAN port models only, repeat Step 2 and Step 3 for the additional WAN interface or interfaces.

To display a report of the Internet traffic by type, click the Traffic by Protocol option arrow in the upper right of the WAN Traffic Meter screen (single WAN port models) or in the upper right of one of the WAN Traffic Meter screens (multiple WAN port models). The Traffic by Protocol screen displays in a pop-up screen. The incoming and outgoing volume of traffic for each protocol and the total volume of traffic are displayed. Traffic counters are updated in MBs; the counter starts only when traffic passed is at least 1 MB. In addition, the pop-up screen displays the traffic meter’s start and end dates.

Figure 272.

Monitor System Access and Performance

465