NETGEAR UTM5EW-100NAS, STM150EW-100NAS manual PPPoE and PPPoA settings, 558

ProSecure Unified Threat Management (UTM) Appliance

6.If your connection is Point-to-Point Protocol over Ethernet (PPPoE) or Point-to-Point Protocol over ATM (PPPoA), your ISP requires an initial login. Enter the settings as explained in the following table:

Table 142. PPPoE and PPPoA settings

Setting	Description
PPPoE	If your ISP uses PPPoE for login, select this radio button, and enter the following settings:
	Account Name	The account name for the PPPoE connection.
	Domain Name	The name of your ISP’s domain or your domain name if your ISP has
		assigned you one. You can leave this field blank.
	Idle Timeout	Select the Keep Connected radio button to keep the connection always
		on. To log out after the connection is idle for a period:
		1. Select the Idle Timeout radio button.
		2. In the time-out field, enter the number of minutes to wait before
		disconnecting.
		This is useful if your ISP charges you based on the period that you are
		logged in.
		Note: When you use a PPPoE connection and select the Idle Timeout
		radio button, you cannot configure load balancing (see Configure Load
		Balancing on page 567). To use load balancing on a PPPoE connection,
		select the Keep Connected radio button. When you have configured
		load balancing, the Idle Timeout radio button and time-out field are
		masked out.
PPPoA	If your ISP uses PPPoA for login, select this radio button, and enter the following settings:
	Account Name	The account name for the PPPoA connection.
	Domain Name	The name of your ISP’s domain or your domain name if your ISP has
		assigned you one. You can leave this field blank.
	Idle Timeout	Select the Keep Connected radio button to keep the connection always
		on. To log out after the connection is idle for a period:
		1. Select the Idle Timeout radio button.
		2. In the time-out field, enter the number of minutes to wait before
		disconnecting.
		This is useful if your ISP charges you based on the period that you are
		logged in.
		Note: When you use a PPPoA connection and select the Idle Timeout
		radio button, you cannot configure load balancing (see Configure Load
		Balancing on page 567). To use load balancing on a PPPoA connection,
		select the Keep Connected radio button. When you have configured
		load balancing, the Idle Timeout radio button and time-out field are
		masked out.

7.In the Internet (IP) Address section of the screen (see the following figure), configure the IP address settings as explained in the following table. Click the Current IP Address link to see the currently assigned IP address.

xDSL Network Module for the UTM9S and UTM25S

558