NETGEAR STM150EW-100NAS manual Balancing Multiple WAN Port Models on page 86 . To use load

ProSecure Unified Threat Management (UTM) Appliance

Table 14. PPTP and PPPoE settings (continued)

Setting	Description
Other (PPPoE)	If you have installed login software, then your connection type is PPPoE. Select this radio
	button, and enter the following settings:
	Account Name	The account name for the PPPoE connection.
	Domain Name	The name of your ISP’s domain or your domain name if your ISP has
		you assigned one. You can leave this field blank.
	Idle Timeout	Select the Keep Connected radio button to keep the connection always
		on. To log out after the connection is idle for a period:
		1. Select the Idle Timeout radio button.
		2. In the time-out field, enter the number of minutes to wait before
		disconnecting.
		This is useful if your ISP charges you based on the period that you are
		logged in.
		Note: When you use a PPPoE connection and select the Idle Timeout
		radio button, you cannot configure load balancing (see Configure Load
		Balancing (Multiple WAN Port Models) on page 86). To use load
		balancing on a PPPoE connection, select the Keep Connected radio
		button. When you have configured load balancing, the Idle Timeout
		radio button and time-out field are masked out.
	Connection	Select the Connection Reset check box to specify a time when the
	Reset	PPPoE WAN connection is reset, that is, the connection is disconnected
		momentarily and then reestablished. Then, specify the disconnect time
		and delay.
		Disconnect	Specify the hour and minutes when the connection should
		Time	be disconnected.
		Delay	Specify the period in seconds after which the connection
			should be reestablished.

7.In the Internet (IP) Address section of the screen (see the following figure), configure the IP address settings as explained in the following table. Click the Current IP Address link to see the currently assigned IP address.

Figure 42.

Manually Configure Internet and WAN Settings

77