NETGEAR STM150EW-100NAS manual See Configure Load Balancing Multiple WAN Port Models, Isp, Dhcp

ProSecure Unified Threat Management (UTM) Appliance

Table 5. Setup Wizard Step 2: WAN Settings screen settings (continued)

Setting	Description
Austria (PPTP)	My IP Address	The IP address assigned by the ISP to make the connection
(continued)		with the ISP server.
	Server IP Address	The IP address of the PPTP server.
Other (PPPoE)	If you have installed login software such as WinPoET or Ethernet, then your connection
	type is PPPoE. Select this radio button and enter the following settings:
	Account Name	The valid account name for the PPPoE connection.
	Domain Name	The name of your ISP’s domain or your domain name if your
		ISP has assigned one. You can leave this field blank.
	Idle Timeout	Select the Keep Connected radio button to keep the
		connection always on. To log out after the connection is idle
		for a period:
		1. Select the Idle Timeout radio button.
		2. In the time-out field, enter the number of minutes to wait
		before disconnecting.
		This is useful if your ISP charges you based on the period that
		you are logged in.
		Note: When you use a PPPoE connection and select the Idle
		Timeout radio button, you cannot configure load balancing
		(see Configure Load Balancing (Multiple WAN Port Models)
		on page 86). To use load balancing on a PPPoE connection,
		select the Keep Connected radio button.
	Connection Reset	Select the Connection Reset check box to specify a time
		when the PPPoE WAN connection is reset, that is, the
		connection is disconnected momentarily and then
		reestablished. Then, specify the disconnect time and delay.
	Disconnect Time	Specify the hour and minutes when the connection should be
		disconnected.
	Delay	Specify the period in seconds after which the connection
		should be reestablished.

Internet (IP) Address

Click the Current IP Address link to see the currently assigned IP address.

Get Dynamically from

ISP

If your ISP has not assigned you a static IP address, select the Get dynamically from ISP radio button. The ISP automatically assigns an IP address to the UTM using DHCP network protocol.

Client Identifier	Select the Client Identifier check box if your ISP requires the
	client identifier information to assign an IP address using
	DHCP.
Vendor Class Identifier	Select the Vendor Class Identifier check box if your ISP
	requires the vendor class identifier information to assign an IP
	address using DHCP.

Use the Setup Wizard to Provision the UTM in Your Network

53