NETGEAR UTM5EW-100NAS manual LED Descriptions, UTM9S, UTM25S, and their Network Modules, Usb Led

ProSecure Unified Threat Management (UTM) Appliance

LED Descriptions, UTM9S, UTM25S, and their Network Modules

The following table describes the function of each LED on the UTM9S and UTM25S and their network modules.

Table 3. LED descriptions UTM9S and UTM25S

LED	Activity	Description
Power LED	On (green)	Power is supplied to the UTM.
	Off	Power is not supplied to the UTM.
Test LED	On (amber) during	Test mode. The UTM is initializing. After approximately 2 minutes, when the
	startup	UTM has completed its initialization, the Test LED goes off.
	On (amber) during	The initialization has failed, or a hardware failure has occurred.
	any other time
	Blinking (amber)	The UTM is writing to flash memory (during upgrading or resetting to
		defaults).
	Off	The UTM has booted successfully.
USB LED	On (green)	A USB device is connected to the USB port.
	Off	A USB device is not connected to the USB port.
LAN ports
Left LED	Off	The LAN port has no link.
	On (green)	The LAN port has detected a link with a connected Ethernet device.
	Blinking (green)	Data is transmitted or received by the LAN port.
Right LED	Off	The LAN port is operating at 10 Mbps.
	On (amber)	The LAN port is operating at 100 Mbps.
	On (green)	The LAN port is operating at 1000 Mbps.
DMZ LED	Off	Port 4 is operating as a normal LAN port.
	On (green)	Port 4 is operating as a dedicated hardware DMZ port.
WAN ports
Left LED	Off	The WAN port has no physical link, that is, no Ethernet cable is plugged into
		the UTM.
	On (green)	The WAN port has a valid connection with a device that provides an Internet
		connection.
	Blinking (green)	Data is transmitted or received by the WAN port.

Introduction

32