NETGEAR UTM5EW-100NAS manual Configure Advanced Radio Settings,  To configure WDS on a peer, 598

ProSecure Unified Threat Management (UTM) Appliance

To configure WDS on a peer:

1.Configure the same wireless security that you have configured on the UTM9S or UTM25S.

2.Enter the MAC address of the UTM9S’s or UTM25S’s access point, which is displayed on the WDS Configuration screen of the UTM9S or UTM25S.

3.Enter the same WPA password or WEP key that you have entered on the WDS Configuration screen of the UTM9S or UTM25S.

Note: Make sure that you use the same wireless security configuration on all WDS peers.

To remove one or more MAC addresses from the WDS Peers table:

1.In the WDS Peers table, select the check box to the left of each MAC address that you want to delete, or click the Select All table button to select all MAC addresses.

2.Click the Delete table button.

Configure Advanced Radio Settings

To configure advanced radio settings:

1.Select Network Config > Wireless Settings > Radio Settings. The Radio Settings screen displays (see Figure 339 on page 581).

2.Click the Advanced option arrow in the upper right of the Radio Settings screen. The Advanced Wireless screen displays:

Figure 346.

Wireless Network Module for the UTM9S and UTM25S

598