NETGEAR STM150EW-100NAS Rear Panel UTM9S and UTM25S, Reset button Console switch, Power, Switch

ProSecure Unified Threat Management (UTM) Appliance

Rear Panel UTM9S and UTM25S

The rear panel of the UTM9S and UTM25S includes the cable lock receptacle, the console port and console switch, the Factory Defaults reset button, the AC power connection, and the power switch.

Security lock		AC power
receptacle		receptacle
Factory Defaults
			Power
reset button
	Console switch		switch
	Console port

Figure 11. Rear panel of the UTM9S and UTM25S

Viewed from left to right, the rear panel of the UTM9S and UTM25S contains the following components:

1.Cable security lock receptacle.

2.Factory Defaults Reset button. Using a sharp object, press and hold this button for about

8 seconds until the front panel Test LED flashes to reset the UTM to factory default settings. Configuration changes are lost, and the default password is restored.

3.Console switch to select the console connection: Main Board (left position), Slot 1 (middle position), or Slot 2 (right position).

4.Console port (9600,N,8,1). Port for connecting to an optional console terminal. The port has a DB9 male connector. The default baud rate is 9600 K. The pinouts are (2) Tx, (3) Rx, (5) and (7) Gnd.

5.AC power receptacle. Universal AC input (100–240 VAC, 50–60 Hz).

6.Power On/Off switch.

Introduction

35